The SAACKE TEMINOX ® GLS The low NO x burner for natural gas, liquid gas and fuel oil EL. Capacity range 4 to 20.5 MW Combustion system The extremely low NOx emission rate in operation with natural gas is achieved by fuel staging, i.e. separating the fuel supply into primary and secondary gas. This initiates a combination of three reduction mechanisms: • combustion of the primary gas with a high premix rate at a low temperature, which also ensures maximum flame stability • reduction of the partial oxygen pressure for the secondary combustion process by means of the combustion gases from the primary zone • reduction of temperature peaks by staging the secondary combustion process deep inside the furnace with a high heat discharge When firing oil, the burner relies on a technology based essentially on the high-pressure atomization principle combined with a mixing-head geometry that varies according to the output. The result: low NO x, efficient combustion performance over the entire control range. Approval and fields of application The TEMINOX ® GLS monoblock and duoblock burners are CE typecertified and DVGW-approved. The product identification no. is CE-0085BL0313. The SAACKE gas racks and the SAACKE burner control system have also been approved for operation as an entity in combination with the TEMINOX ® GLS. Since its market introduction in 1998, the TEMINOX ® GLS has been operating in every industrial and heat management sector worldwide with excellent performance results. It is designed for application with three-pass, water-tube, reverse-flame and thermal-oil boilers. Low NO x limits can be met without difficulty even with preheated air. Waste gas emissions The TEMINOX ® GLS keeps the NOx emissions safely below the limits currently in effect. This is documented by measurements taken at more than 600 plants implemented to date. The photograph shows a plant with a TEMINOX ® GLS 95-22 monoblock burner on a 13.2 t/h three-pass boiler. Monoblock burner The monoblock version of the TEMINOX ® GLS – i.e. with the fan integrated in the burner – offers numerous advantages: • the mixing system and fan casing modules can be selected precisely to suit the configuration of the plant • it can be used even when very high backpressure is created by an economizer, the layout of the flue gas duct, an unusual boiler design etc. • the mirror-image design of the fan casing with left/right swing-out is ideal for use with double-flame-tube boilers • no elaborate planning work is needed for fan installation or air duct configuration • time-saving installation thanks to the compact design • quick cost-effective commissioning • sound absorption is available for reduction by 10 to 35 dB(A) Capacity range The capacity spectrum of the TEMINOX ® GLS stretches from 4 to 20.5 MW. Depending on the size of the model and the equipment options selected, the turn-down ratio for gas is approx. 1:7 and for fuel oil EL approx. 1:3. Fuel Capacity [MW] 0.54 5.4 1.35 5.4 0.8 7.5 1.85 7.5 1.0 9.5 2.5 9.5 1.2 12.0 3.2 12.0 1.5 15.2 3.5 14.0* 2.0 18.5 3.8 4.2 14.0* 20.5* Monoblock burner size 55 75 95 125 155 185 ––– Duoblock burner size 60 80 100 130 160 190 220 Light oil/gas GLS Gas GS Light oil LS * Light oil >14 MW upon request
The photograph shows a plant with eight TEMINOX ® GS 190 duoblock burners on four 50 t/h double-flame-tube boilers in a paper mill. Two of the burners are equipped with an additional mixing system for biogas and operate both with natural gas only and with natural gas and biogas in dual-fuel operation. Duoblock burner The duoblock version of the TEMINOX ® GLS – i.e. with the burner and the fan located apart from one another – has the following advantages: • it can operate with extremely high plant draft losses and with preheated air • its space-saving casing is ideal for confined areas • multiple-burner plants can be operated with one central fan • the angle of the air inlet can be chosen in increments of 22.5 degrees • it can fire non-standard fuels and fuel combinations • commissioning is quick and inexpensive Burner selection / Modular options The many options available make the monoblock version of the TEMINOX ® GLS the best solution to many different problems confronted by the plant with regard to output and furnace pressure. Depending on the output required and the backpressure, the burner head and the fan can be combined to create up to three different models. The load diagram shows the maximum burner output depending on the static furnace pressure. Static furnace pressure in mbar 35 30 25 20 15 10 5 55 75 95 125 155 185 55-18 55-15 75-22 75-18 95-37 95-30 95-22 125-45 125-37 155-45 125-30 155-37 185-45 0 4 6 8 10 12 14 16 18 20 Burner capacity in MW Equipment The burners in the TEMINOX ® series are available as GLS combination-type burners, GS gas burners and LS light oil burners. They can be supplied as monoblock or duoblock models, offering a selection of advantages: • a modular-design low NOx mixing system • on the monoblock model, a high-efficiency fan and sound absorption inside the casing; burner swing-out right and left; speed-controlled fan motors equipped with a thermistor protection unit. • a sound absorption cabin for high standards of noise reduction • free choice of the air inlet angle on the duoblock model at 22.5 degree increments • high-efficiency fans for the duoblock burners • a return line pressure jet atomizer with hydraulic tip shut-off needle for fuel oil EL • gas dampers and oil flow controllers with linearized action • a pre-configured and tested gas rack • monitoring equipment for 72-hour unattended operation in compliance with TRD • a gas-electric igniter; for oil operation direct electric ignition without ignition gas • a burner management system with electronic compound control, either mounted on the burner and ready for operation or for installation in the control cabinet Facts that speak for themselves • a range of capacities from 4 to 20.5 MW with a large turn-down ratio • ultra-low NO x technology well in advance of future emissions restrictions • all-inclusive solutions from a single source that keep the project work at a minimum • modular mixing system, fan and sound absorption equipment that can be adapted to the requirements of any plant • time-saving installation and commissioning • an optional biogas mixing system for the TEMINOX ® duoblock burner Combustion and Energy Systems
View Victor Daniel Carletti’s profile on LinkedIn, the world's largest professional community. Victor Daniel has 10 jobs listed on their profile. See the complete profile on LinkedIn and discover Victor Daniel’s connections and jobs at similar companies. The SAACKE SKVJ-M monoblock rotary cup burner is designed for smaller sized marine boilers. It is suitable for - side fired furnace boilers and - classic two- or three-pass smoke tube boilers The.